FISCHER 18092 Mode D'emploi page 33

Step 7
Adjusting the width of the carrying unit to the width of the guide rails.
The guide rails are mounted to the base
support.
1. Loosen clamp screws (1e+2c) on the
carrying unit (do not screw off completely).
The inserted round tubes can be moved.
CAUTIOn!
The minimum inserted length is
65 mm. A marking is visible when
the maximum width is reached.
1e
2. Insert in the back guide roller (1d) on the
carrying unit on one side into the opening on
the guide rail move the other side until the
guide roller (1d) fits into the opening on the
guide rail and insert.
18092_Betriebsanleitung_D_GB_F_IT_PL.indd 33
3. Carefully lean the carrying unit with foam
profile (2b) on the side of the vehicle and
verify that the retaining tube is directly in
the middle of the left and right side – move
to the middle if necessary. Again verify that
the maximum width is not exceeded (heed
marking).
4. Fasten clamp screws (1e) on the carrying
unit.
1e
2c
5. As described in Step 10, lift the carrying
unit and set the width of the bike carrying
bracket so that the front guide rollers (1c)
fit into the openings on the guide rails.
Then fasten clamp crews (2c) and lower the
carrying unit, as described in Step 11, back
onto the side of the vehicle.
Retaining tube
33
13.02.15 11:25