FISCHER 18092 Mode D'emploi page 36

Step 10
Lifting the carrying unit onto the vehicle roof
The following parts are required for this
assembly step.
Parts No. Image
Hex key, 5 mm
23
The profile guides are mounted. The entire
carrying unit can now be lifted onto the roof of
the vehicle.
1. Hold the carrying unit on the left and right
near the foam profile (2b) and lift upward.
2. When you reach the horizontal position,
push the carrying unit back until the front
guide rollers (1c) hit the guide rails (3+4).
36
18092_Betriebsanleitung_D_GB_F_IT_PL.indd 36
Quantity
1
3. Slightly lift the carrying unit at the front and
lower the front guide rollers into the opening
on the guide rails.
4. Push the carrying unit further back until the
safety clamps (2a) click into the opening on
the guide rails themselves. Tighten the hand
wheel (1f) left and right.
5. After the carrying unit is inserted into the
rails, you need to set the attachment point
on the opposite side exactly.
13.02.15 11:25