FISCHER 18092 Mode D'emploi page 35

Step 9
Assembling the profile guides (5) on the carrying unit
The following parts are required for this
assembly step:
Parts No. Image
Bike profile guide 750 mm
5
Washer,
7
6.5 mm, small
Washer,
8
6.5 mm, large
Screw M6 × 35 mm
10
13
Cap nut M6
The width of the carrying unit is adjusted
properly and the carrying unit is inserted
through the guide rails (3+4).
Current position:
Carrying unit leaning on side of vehicle.
1. Hold the profile guide (5) to the top of the
bike carrying bracket.
2. Insert screw (10) first through the washer
(8), then from above through the hole on the
bike carrying bracket.
3. Attach the washer (7) to the bottom and
screw on cap nut (13).
nOTe:
Please note that the overhang of
the profile guide is the same on the
left and right.
18092_Betriebsanleitung_D_GB_F_IT_PL.indd 35
Quantity
2
4
4
4
4
10
10 5 5
8 8
7 7
13 13
35
13.02.15 11:25