Symbols On The Product - Husqvarna AUTOMOWER 105 Manuel D'utilisation

12. Cutting system
13. Chassis box with electronics, battery and
motors
14. Main switch
15. Handle
16. Blade disc
17. Skid plate
18. Contact strips
19. LED for operation check of the charging
station and boundary wire
20. Charging station
21. Power supply
22. Cable markers
23. Measurement gauge when installing the
boundary wire (the measurement gauge is
broken loose from the box)
24. Screws for securing the charging station
25. Operator's Manual and Quick Guide
26. Alarm decal
27. Extra blades
28. Low voltage cable
29. Couplers for the loop wire
30. Loop wire for boundary loop and guide wire
54
55
31. Stakes
32. Connectors for the loop wire

34.10 Symbols on the product

These symbols can be found on the product.
Study them carefully.
53
Is a part of the Installation kit which is purchased separately.
54
See note 1
55
See note 1
56
See note 1
903 - 001 - 21.09.2018
53
56
WARNING: Read the
user instructions before
operating the product.
WARNING: Operate the
disabling device before
working on or lifting the
machine.
The product can only start
when the main switch is
1 and the correct
set to
PIN code has been en-
tered. Turn the main
switch to
rying out any inspections
and/or maintenance.
WARNING: Keep a safe
distance from the machi-
ne when operating. Keep
your hands and feet away
from the rotating blades.
WARNING: Do not ride
on the machine. Never
put your hands or feet
close to or under the ma-
chine.
Never use a high-press-
ure washer or even run-
ning water to clean the
product.
This product conforms to the
applicable EC Directives.
Noise emission to surroundings. The
product's emissions are set out in
and on the rating plate.
It is not permitted to dispose this
product as normal household waste.
Ensure that the product is recycled in
accordance with local legal
requirements.
0 before car-
#
Introduction - 91