Maintenance And Cleaning; Accessories - IKA T 65 digital ULTRA-TURRAX Mode D'emploi

Switching the T 65 digital ULTRA-TURRAX
- EMERGENCY STOP switch / power switch (A)
Operation: The main switch is marked yellow/red and functions
also as an EMERGENCY STOP switch. If the main switch is actu-
ated the unit is deenergised.
- Turn the "EMERGENCY STOP switch" rotary knob (A) clockwise,
the unit is supplied with power. "rdy" (ready) appears on the
display (F).
- Set the "Speed setting" rotary knob (E) to the lowest value
(10%).
- Press the "Start" button (D) on the front membrane. The unit
starts up at 1000 rpm with smooth start.
CAUTION! Membrane buttons must be kept pressed for at
least a second for a command to be acknowledged.
- Slowly turn the "Speed setting" rotary knob (E) to the desired
setting. The actual speed appears on the display (F).
- Keep the "Stop" button (B) pressed for at least a second to stop
the unit. The unit starts up slowly. "rdy" (ready) appears again
on the display (F).
When slowing down, "dEC" (decrease) is displayed; after com-
ing to a stop "rdy" (ready) is displayed.
- In emergency actuate the "EMERGENCY STOP switch" by turn-
ing the "EMERGENCY STOP switch" rotary knob (A) anticlock-
wise. The unit is deenergised, and the display (F) goes out.
The device operates maintenance-free.
As necessary, but in any case not less than every six months, the
following points must be checked:
- EMERGENCY STOP switch operation
- Safety limit switch operation (with the stand in the lower position)
- Electrical consumers, connections and cables for damage.
Cleaning:
For cleaning disconnect the main plug!
Use only cleaning agents which have been approved by IKA to
clean the devices:
These are: water (containing surfactant) and isopropyl alcohol.
- Wear protective gloves during cleaning the devices.
- Electrical devices may not be placed in the cleansing agent for
the purpose of cleaning.
- Do not allow moisture to get into the device when cleaning.
- Before using another than the recommended method for
cleaning or decontamination, the user must ascertain with IKA
that this method does not destroy the device.
T 653
SI 400
SI 474
See more accessories on www.ika.com.
unit on and off:
®

Maintenance and cleaning

Accessories

Telescopic stand
Safety limit switch
Support holder
F
E
D
B
Spare parts order:
When ordering spare parts, please give:
- Machine type
- Manufacturing number, see type plate
- Item and designation of the spare part,
see www.ika.com, spare parts diagram and spare parts list
Repair:
Please send instrument in for repair only after it has been
cleaned and is free from any materials which may consti-
tute a health hazard.
For this you should request the "Decontamination Clearance
Certificate" from IKA, or use the download printout of it from
the IKA website www.ika.com.
Return the instrument in its original packaging. Storage packag-
ing is not sufficient. Also, please use suitable shipping package
materials.
S 65 KG-HH-G 65 G
S 65 KG-HH-G 65 M
S 65 KG-HH-G 65 F
A
C
Fig. 5
Dispersion tool coarse
Dispersion tool medium
Dispersion tool fine
19