Cleaning The Sensors; Changing The Batteries In The Remote Control - Miele SLQL0 Mode D'emploi

Masquer les pouces Voir aussi pour SLQL0:
Table des Matières

Publicité

en
 Unclip the cover.
 Remove the front wheel.
 Remove any threads and hair and
clean the front wheel, the cover and
the slot depression using the cleaning
tool.
 Refit the front wheel and close the
cover making sure it clicks into posi-
tion.

Cleaning the sensors

Clean the sensors as required.
 Place the robot vacuum cleaner up-
side down on a level, clean surface.
 Clean the sensors carefully using a
dry cotton wool bud.
60
Keep batteries out of the reach
of children.
A swallowed battery can cause injury
and even death. Even flat batteries
can still be dangerous. If you suspect
a child has swallowed a battery, seek
medical advice immediately*. Exam-
ine devices and make sure the bat-
tery compartment is correctly se-
cured, e.g. that the screw or other
mechanical fastener is tightened. Do
not use if compartment is not secure.
* Australia: Poisons Information
Centre, Tel. 13 11 26;
NZ: National Poisons Centre,
Tel. 0800 764 766
Changing the batteries in the remote
control
The remote control requires two 1.5 V
(AAA) batteries.
 Remove the battery compartment
cover.
 Exchange the batteries. Take care
with the polarity.
 Close the battery compartment cover.
 Observe the special instructions re-
garding the handling and disposal of
batteries found in the sections "Warn-
ing and Safety" and "Caring for the
environment" at the beginning of
these operating instructions.

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Slql0 serieSlql0 rx2

Table des Matières