Miele SLQL0 Mode D'emploi page 51

The robot vacuum cleaner will travel in
the desired direction without vacuum-
ing.
You cannot direct the robot vacuum
cleaner manually to the base station in
order to recharge it.
Directing the robot vacuum cleaner
to the base station
(only possible when vacuuming was
started from the base station)
 Press the Base button on the remote
control or the Base sensor field on
the display.
The robot vacuum cleaner will travel to
the base station and recharge.
Finishing vacuuming manually
 Press the Power button on the re-
mote control.
The robot vacuum cleaner will switch
into standby after approx. 60 seconds.
The display is deactivated, the re-
chargeable battery status indicator con-
tinues to light up.
You can switch the robot vacuum
cleaner into standby before
60 seconds is up by pressing the
Power button again.
The robot vacuum cleaner is reactivated
by pressing any button on the remote
control or one of the sensor fields in the
display.
Operating modes
There are five different operating op-
tions.
Auto
Standard vacuuming for
normally soiled flooring.
Spot Targeted vacuuming of an
area approx. 1.8 x 1.8 m
around the selected starting
point of the robot vacuum
cleaner.
Base
Directing the robot vacuum
cleaner to the base station.
Turbo
For vacuuming lightly soiled
flooring with a short vacu-
uming duration.
Silent
Vacuuming with low noise
development.
en
51