Troubleshooting Guide - Vitrifrigo C25L Manuel D'instructions

that the refrigerator is not connected to any electrical supply. If connected, unplug the
appliance from the electrical supply.
To replace the LED light profile:
1. Remove, perpendicular to the base, the protective cover, being careful not to
damage the fixing pins.
2. Disconnect the light's power cables.
3. Replace the LED light profile.
4. Connect the power source.
5. Replace the cover.

10. TROUBLESHOOTING GUIDE

What to do if the fridge doesn't work
Problem
No electrical current
The refrigerator
does not start
Try running a reset
Thermostat in "STOP"
The refrigerator
does not cool
The refrigerator
temperature is too
does not stop
The courtesy
light does not The light is faulty
switch on
The refrigerator
is noisy
If you do not manage to achieve regular operation after these checks, contact the
customer assistance service.
Cause
Check that the voltage on the terminal block of the appliance's
position
Insufficient (b) the refrigerator is not near heat sources and is sufficiently
output
The internal
high
Check that the refrigerator sits flat and is not in direct contact
Solution
Check that the power supply cable is intact
and properly connected.
DC mode: Check that the battery is charged
electronic device is the same as that of the battery.
Disconnect the power cable.
Wait for a minute and then reconnect it.
Move the thermostat to the recommended position
Check that:
(a) the door closes hermetically;
ventilated;
(c) the condenser is not clogged with dust.
Check that the door is completely closed
Call the service centre
with any object that might cause vibrations.
ENG 29