Appliance Recess, With Ventilated Remote Motor - Vitrifrigo C25L Manuel D'instructions

Masquer les pouces

Table des Matières

Les langues disponibles

The recess must respect the minimum distances between the appliance and the

surrounding structure and it must have suitable ventilation openings communicating

directly with the open space in the room, in order to obtain correct air circulation by

means of the chimney effect, as indicated in annex 2 - figure 2

The recess must ensure that all possible live parts of the appliance are not directly

accessible as well as the ventilation openings, by fitting them with suitable grilles.

The grilles must have openings with max. dimension of 5 mm.

The envisioned ventilation openings are:

with dimension no less than 120 mm in height for the dimension of the refrigeration

in width if positioned behind, which must always be associated to another opening

of at least 120x12 mm positioned on the side of the condenser (anx.2 - fig.2).

of dimensions 120x120mm if positioned on both sides, as indicated in annex 2 - fig.2

La distanza minima tra le varie parti dell'apparecchio e la struttura di incasso non deve

essere inferiore a 75mm. (anx.2 - fig.2)

For recess situations in spaces where the minimum distance of 75mm is respected only

in the rear part of the appliance, make the ventilation openings on the same side

respecting the indications for the position, number and dimensions shown in fig.2.

For recess situations with surfaces in contact with the upper and lower parts of the

appliance, make the ventilation openings at the top and bottom of the appliance as

indicated in fig.2.

In all the situations of the described ventilation openings, only the minimum distance of

75mm from the sides of the appliance may not be observed.