Appliance Recess For Campers, Caravans And Motor-Homes; Fixing The Appliance; Electrical Connection; Important - Vitrifrigo C25L Manuel D'instructions

Appliance recess for campers, caravans and motor-homes.

To install the refrigerator or fridge units in a caravan, camper van, motor home etc.
make the recess space in the vehicle with ventilation vents directly on the outside, fitted
with suitable grilles to ensure that all possible live parts of the appliance are not directly
accessible (thermostat, electronic module and fan).
The grilles must have openings with max. dimension of 5mm and be on at least one side
(see annex 2 fig. 1-2-3).
ATTENTION Keep ventilation openings free from obstructions in the recess.
Do not place any objects or other materials near the ventilation grilles, nor cover
or block them.

Fixing the appliance.

To secure the appliance in the recessed area, use the holes on the front base or the
internal bushings of the refrigerator and screws or the special fixing frame if present (see
annex 3).

6. ELECTRICAL CONNECTION

ATTENTION (only for models with alternating current):
The operator must be able to disconnect the appliance from the mains electricity.
Make sure that there is an access point to the mains electricity and/or that the plant has
a 6A differential magnetothermal switch with minimum 3 mm opening of the contacts.
Before connecting the product, make sure that the voltage corresponds to that shown
on the identification label or that shown on the label on the compressor.
IMPORTANT: by law, the appliance must be grounded. Make sure that the grounding
system for the electrical network is working perfectly.
We accept no responsibility whatsoever for any injury to people or damage to property
deriving from the failure to properly comply with this regulation.
The use of adaptors, multiple sockets and extension cords is not recommended.
In the event that the appliance's plug and the socket are not compatible, replace the
plug with a suitable one.
This operation must be done by a suitably qualified person who must ensure that the
cable section of the plug is appropriate to the power absorbed by the appliance.
Do not interconnect any other type of appliance to the refrigerator.
ELECTRIC CONNECTION FOR 12-24Vdc and 12-24 Vdc / 100-240 Vac 50/60Hz models
It is recommended to connect the 12Vdc or 24Vdc power supply line directly to the
battery by following the corresponding instructions of the supplied control unit (see
annex 4).
ENG 25