Maintenance And Safety (All Models) - Vitrifrigo C25L Manuel D'instructions

label on the compressor.
• Once installation has been completed, check that the refrigerator is not resting on a
power cable.
• If the power supply cable is damaged it must immediately be replaced by the
technical assistance service or by qualified personnel.
• Place the refrigerator away from heat sources, making sure that there is sufficient
ventilation
• We recommend that you wait at least one hour before switching the refrigerator on,
in order to allow the refrigeration circuit to be completely efficient.
• We recommend leaving sufficient space to be able to disconnect the appliance
from the power supply, should the need arise.
• Series C refrigerators must be used with recessed installation.
ATTENTION:

Maintenance and safety (all models)

• Maintenance of the refrigerator must be only be carried out by qualified staff.
• Before carrying out any maintenance or cleaning operation, disconnect the power
plug.
• Keep ventilation openings free from obstructions.
• Contact a suitably qualified person to clean the ventilated condenser.
• Always carry out the inspections, checks, and scheduled maintenance described in
this manual.
• Do not attempt to remove, modify or repair the refrigerator.
• For any operational problems contact the Vitrifrigo Service Centre closest to you; in
any case, request the assistance of a suitably qualified person.
• Do not store explosive substances in this appliance such as aerosol cans with
flammable propellant.
• The appliance must not be cleaned with a jet of water.
• For appliances intended to be used at altitudes higher than 2000 m, contact the
manufacturer.
• The environment in which the appliance is installed must be adequately ventilated if
possible.
• If the environment, in which an appliance containing a flammable refrigerant is used,
is not ventilated, the environment must ensure that, should any gas leak, it cannot
reach a concentration such as to cause a fire or explosion as a result of a heat source
20 ENG
To avoid any hazard caused by the appliance being unstable, it must
be fixed according to the instructions.