Product Description; Assembly And Start-Up - Oase Wall Spout LED Set Mise En Service

• Ensure that the unit is protected via a fault current protection device with a rated fault cur-
rent of max. 30 mA installed in the mains. If necessary, contact a qualified electrician.
• Protect open plugs and sockets from moisture.
Safe operation
• Do not look directly into the light source.
• Do not use the unit, if electrical lines or the housing are damaged.
• A damaged connection cable cannot be replaced. Dispose of the unit.
• Do not carry or pull the unit by its power cable.
• Route lines in such a way that they are protected from damage and do not present a tripping
hazard.
• Should problems occur, please contact the authorised customer service or OASE.

Product Description

1 LED spotlight
2 Power pack (LED driver)

Assembly and start-up

 A, B, C
• Position the power pack at least 2 m from the edge of the pond.
• Connect the connection cable of the spotlight to the socket on the power pack and hand-
tighten the union nut.
Switching on the unit: Insert the power plug of the power pack into the socket. The unit
switches on immediately.
Switching off the unit: Pull the power plug of the power pack.
6
LED0011