Product Description; Accessories; Installation And Connection - Oase LunAqua Power LED XL Notice D'emploi

Product Description

LunAqua Power LED XL is a sturdy spotlight with LED lamps permitting simple and safe operation above and below
water (up to 4 m).

Accessories

LunAqua Power LED Cable 10 m (42636) as extension cable between driver and spotlight.
Intended use
Exclusively use the LunAqua Power LED XL as follows:
• For use in water fountain systems and ponds.
• For use above and under water.
• Operate in accordance with instructions. (→ Technical data)
• Connection to a suitable OASE driver.

Installation and connection

W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
N O T E
The unit is sensitive. Hard impacts and vibrations may damage mechanical or electronic components.
• Protect the unit from hard impacts or vibration.
The device can be installed in or outside of the water.
• Never cover the unit, as this will result in a risk of fire.
• For installation outside of the water, keep a minimum safety distance of 50 cm from combustible material.
Place the unit horizontally on the ground ensuring its stable position.
• A ground stake can be used for installation outside of the water.
Installation with the ground stake
How to proceed:
 B
1. Insert a square nut into the spotlight on both sides.
2. Turn the clamping screws into the square nuts by several rotations, then insert the spotlight in the holding fixture.
– If necessary, adjust the tilt of the spotlight. (→ Adjusting the tilt of the spotlight)
3. Tighten the clamping screws.
4. Insert the ground stake in the ground.
5. Install the unit on the ground stake.
- EN -
13