Cleaning And Maintenance - ExtraStove ES 11 Manuel D'installation

5.2 Messages Operation
Description
Ignition starting
Ignition wait
Heat
Manual
Automatic
Cooling starting
Set date-time
Weekly programming
Thermostat mode
Internal thermostat
External thermostat
Programmable thermostat / GSM Program
Stove parameters
System log
Select language
6.0 How to use the air ducting (where present)
The ductable stove is equipped with an independent SELECTORS adjustment system,
which is located under the door of the pellets tank in the upper part of the stove.
ATTENTION!
Selector must be used only when the stove is cold.
The SELECTORS adjustment system, allows the air distribution independently (right side and left
side), according to the needs, simply by moving the SELECTORS in positions A-B-C-D-E.
- Lifting and moving the knob in position "A" the air flow is conveyed 100% at the front of the stove.
- Lifting and moving the knob in position "B" (where installed), the airflow is conveyed 75% at the
front of the stove and 25% on the rear of the stove.
- Lifting and moving the knob in the position "C" the airflow is conveyed 50% at the front of the
stove and 50% at the rear of the stove.
- Lifting and moving the knob in the position "D" (where installed), the airflow is conveyed 25% at
the front of the stove and 75% at the rear of the stove.
- Lifting and moving the knob in position "E" the airflow is conveyed 90% at the rear of the stove.

7.0 Cleaning and maintenance

Before effecting any maintenance operation or cleaning on the stove, take the following
precautions:
• Be sure that all parts of the stove are cold.
• Be sure that the ashes are completely cold.
• Be sure that the general switch is in the "OFF" position.
• Be sure that the plug is pulled out of the socket to avoid accidental contact.
• Once the maintenance phase is completed check that everything is in order as per
before the intervention (the brazier is placed correctly).
Follow carefully the following cleaning instructions. Failure to follow
these instructions could create problems with the operation of the
stove.
7.1 How to clean the combustion chamber for models ES/ESRC
11-13 (once a month)
- open the door and remove the brazier and the ash tray (fig. 1)
- unscrew the 2 screws in the central bulkhead (fig. 2)
- pull the central bulkhead towards outside and, at the same time, support and take off
the fire heater placed on the upper part (fig. 3-4)
- unscrew the 2 screws and remove the flap (fig. 5-6)
- remove the inside right and left bulkheads pulling outward (fig. 7-8)
- remove the bottom part pulling up and laterally (fig. 9-10)
- scrape the inner pipes with a wire brush (fig. 11-12)
- use a vacuum cleaner to remove the ash from the combustion chamber (fig. 13), be-
hind the exchanger pipes (fig. 14) and inside the brazier (fig. 15)
- do the reverse process to re-assemble.
Display
Ignition
Starting
Heating
Manual
Automatic
Cooling
Set date-time
Weekly prog.
Thermostat mode
Internal therm.
External therm.
Cro/GSM Prog.
Stove parameters
System log
Select language
21
Fig. 1 Fig. 2
Fig. 3 Fig. 4
Fig. 5 Fig. 6
Fig. 7 Fig. 8
Fig. 9 Fig. 10
G