Dri-Eaz LGR 2800i Manuel D'utilisation page 2

FIG A: PARTS IDENTIFICATION
FRONT
Power cord and
drain hose
storage.
Humid air inlet.
Air filter.
Front panel. Remove to
access the pump and
coils for cleaning. See
Drain hose
Fig. B.
quick-connect.
REAR
Integrated handle. Use the
red lever to lock handle
upright for use or down
for loading or storage.
Control panel.
Power cord
socket.
Drain hose quick-
connect.
Model serial
number label
Process (dehumidified)
air outlet.
Positioning a Dehumidifier
For best results, operate your dehumidifier in an
enclosed area. Close all doors and windows to maximize
the unit's water removal efficiency. Place your
dehumidifier away from obstructions, and keep it away
from anything that could obstruct airflow into and out of
the unit.
07-02300A F600 (115V)
Extend handle
Release the handle by rotating red
locking lever outward, then lift handle
up into place. Rotate red lever back
into locked position to secure handle
in operating position.
NOTICE: Do not use the extended
handle to lift the unit off the ground
horizontally. Do not use the extended
handle as an attachment point to strap
the unit in a vehicle for transport.
These uses will place undue strain on
the handle attachment points in the
housing.
Set up drain hose
This unit automatically pumps out
water on a regular basis. This
dehumidifier is equipped with a quick-
connect fitting for attachment to the
provided 40 ft. (12 m) drain hose
located in the tray on top of the unit.
Unwrap the entire hose and place the
open end in a sink, drain, bucket or
outdoors – anywhere that water can
drain out safely. If you use a bucket or
other container for water collection,
check it regularly to prevent overflows.
NOTICE: Uncoil and straighten the
entire drain hose. Do not leave any
part of the hose coiled on the unit and
do not place the end of the hose
higher than 20 ft. (6 m) above the
bottom of the unit. Also check for
kinks or other obstructions that might
restrict the flow of water. A kink or
blockage will cause the unit to turn off
produce an ER9 error code. See
"Error Messages," p. 8 for more
information.
Plug in electrical cord
The dehumidifier should be
plugged into a GFCI-protected 115
volt outlet rated for at least 15 amps.
Remove the cord from the storage
tray and uncoil it. Always plug the cord
firmly into the unit first, and then plug
the other end into a suitable electrical
outlet.
Startup display and normal display modes
When unit is first plugged into AC power, the control
panel display will briefly cycle through a series of
readouts. This is part of the unit's self-diagnosis
procedure and no user intervention is required.
2 Dri-Eaz Products, Inc.