User Keypad & Whirlpool Modes/Features; Operating Your Whirlpool - Kohler K-1330 Guide D'utilisation

Heater Indicator
Light
Heater
On/Off
Power
On/Off
Lighted User Keypad
User Keypad and Whirlpool Modes/Features
S
Power - Turns the whirlpool pump on and off.
S
Up Arrow - Increases the water flow.
S
Down Arrow - Decreases the water flow.
S
Heater - The heater automatically engages when the whirlpool is turned on. You may turn the heater off by
pressing the heater button. Press the button a second time to turn the heater back on.
S
Indicator Bar - Shows the water flow volume.

Operating Your Whirlpool

- Position the jet nozzles so they face down toward the basin. Turn the jet trim fully counterclockwise.
The water temperature in the whirlpool should never exceed 104_F (40_C). A built-in heater automatically
maintains the water temperature when the whirlpool is running, as long as the water temperature does not
exceed 104_F (40_C). The heater will disengage at higher temperatures.
- Close the drain, and fill the whirlpool to a level at least 2" (5cm) above the top of the highest jet. Use your hand to
test the water temperature for comfort and safety, then carefully enter the bath.
- Press Power to turn on the whirlpool. The whirlpool will start at medium volume. The heater will turn on and the
heater icon will illuminate.
- Increase or decrease the water flow by pressing the up or down arrows on the keypad. An indicator bar in the
center of the keypad shows the water flow volume.
- Adjust the jets for optimum air/water mixture. Turn the jet trim clockwise to reduce the flow, and
counterclockwise to increase the flow. Position the jet nozzles to direct the water flow as desired to maximize your
hydro-massage experience.
- The heater automatically engages when the whirlpool is turned on. You may turn the heater off by pressing the
heater button, when the heater mode is active. Press the button a second time to turn the heater back on.
- Press Power a second time to turn off the whirlpool.
Your whirlpool will automatically stop after approximately 20 minutes of continuous operation. You can restart
the whirlpool, if you desire, by pressing Power.
- Carefully exit the bath, and open the drain to empty the whirlpool.
If the whirlpool does not function properly, please refer to Troubleshooting on Page 9.
Kohler Co.
Increases
Flow
Indicator Bar--
Shows water
flow volume
Decreases
Flow
Fill with water 2" (5cm)
above the highest jet
Turn the jet trim
clockwise to
decrease the flow
5
Position the jet
nozzles to direct
the water flow as
desired
Turn the jet trim
counterclockwise to
increase the flow
1023350-5-
A