Chromatherapy Operation; User Keypad "Sleep" Modes - Kohler K-1397 Guide Du Propriétaire

Operating Your Whirlpool (cont.)
Flexjets: When activated, the Flexjets, located lower in your whirlpool than the Riverjets, will start
to flow at medium volume immediately. Increase or decrease the water flow by pressing either the
up or down arrow buttons on the keypad. An indicator bar in the center of the keypad shows the
water flow volume.
Whitewater: Whitewater mode activates the two outside Riverjets behind your neck to flow at
medium volume. Increase or decrease the water flow by pressing either the up or down arrow
buttons on the keypad. An indicator bar in the center of the keypad shows the water flow volume.
Rapids: Rapids mode activates all four Riverjets behind your neck to flow at medium volume.
Increase or decrease the water flow by pressing either the up or down arrow buttons on the keypad.
An indicator bar in the center of the keypad shows the water flow volume.
Tidepool: This feature turns off the air flow to the jets for a soothing, relaxing effect. The Tidepool
feature may be used at any time while any of the jets are operating. The Tidepool mode does not
affect the Waterfall.
NOTE: Some air may flow from one or more jets for a short time after the Tidepool feature has been
activated.
Heater: The built-in heater automatically helps to maintain the water temperature when any of the
jets are operating, as long as the water temperature does not exceed 104° F (40° C). The heater may
be turned off at any time while the pumps are operating, by rotating the outer ring until the heater
button is flashing and pressing "OK". Press "OK" again to turn the heater back on.
Your whirlpool jet system adds air to the water stream (when not in the Tidepool mode) to increase
the force of the water flow. Decrease the force of the whirlpool water flow by turning the whirlpool
trim rings clockwise until you obtain the desired water force. Turn the trim rings counterclockwise
to increase the water flow force.
NOTE: A built-in timer automatically stops the pump and motor after approximately 20 minutes of
operation.
Press the Power On/Off button to turn the whirlpool off.

Chromatherapy Operation

NOTE: Chromatherapy may be used with all modes of operation. Chromatherapy may also be used when
the pumps are not operating.
Chromatherapy Cycle - When this mode is activated, the chromatherapy lights will automatically
and continuously cycle through all eight colors: white, violet, indigo blue, aqua blue, green, yellow,
orange, and red. One cycle through all eight colors takes approximately one minute. Rotate the
outer ring to select this mode and press "OK" to activate it. Press "OK" while the chromatherapy
mode is active to turn off the lights.
Chromatherapy Specific Color Selection - When this mode is activated, you may choose a specific
color for the bath. Rotate the outer ring to select this mode, press "OK" to activate and use the
up/down arrows to reach the desired color. Press "OK" while the chromatherapy mode is active to
turn off the lights.

User Keypad "Sleep" Modes

To enhance your bathing experience, the keypad is programmed to darken after approximately 15
seconds of inactivity. Only the last feature selected will remain illuminated. To resume normal
operation, press any key or turn the outer ring.
Approximately 60 seconds after all equipment is turned off, the keypad will darken completely to
conserve power. Press the power button or turn the outer ring to reactivate the keypad.
1022205-5-C 8 Kohler Co.