GUTMANN Rayo Notice De Montage page 17

12. Lift up the extractor hood and push it
into the upper tower, so that the pre-
pared oblong holes align with the fas-
tening holes in the module.
13. Fasten the cooker hood to the upper
tower (using the enclosed 15 M5
screws).
14. By removing the adhesive tape,
loosen the lower tower and pull down
until it is positioned on the hood.
15. Carry out a functional test!
Single-piece tower unit
1. Remove plastic blind plugs on module
(4 pcs.)
2. Unscrew the sheet metal screws on
the module (4 pcs.)
3. Push the metal clips into the tube and
engage in the groove, with a hammer, if
necessary (4 pcs.)
en
17