Jotul F 370 Advance Manuel D'installation Et D'utilisation page 14

ENGLISH
4.4 Location of approval label
Fig. 11
A
5. Attach the approval label, which is inside the ash pan, to
the underside of the burn chamber's heat shield. (This
label is important for the approval of the product).
Fig. 12
C
D
1. Put the rear plate into place (A) in the base.
2. Secure the heat shield provided (A) to the burn chamber
using the screws (B) and sleeves (C) from the bag of screws.
3. Level the product using the 4 adjustment screws (D).
NB: If using a glass fl oor plate (optional extra), the
base must be raised approximately 8 mm from the
fl oor so that the fl oor plate can be pushed under the
front edge of the base.
4. If an external air supply is to be used, pull the fl ex hose
through the hole in the bottom plate and attach it to the
smoke outlet using a hose clip. Make sure the hose is long
enough so that joints are not necessary.
14
C
A
B
B
D
D
D
Jøtul F 373 Advance - product with pedestal
Fig. 13
B
• The outside air inlet (A) with opening (B) is located at the
rear of the burn chamber as standard.
Fig 14
NB: If using an external air supply through the fl oor, the outside
air inlet (A) must fi rst be rotated (fi g. 18 A).
A
A