REMA CPH Mode D'emploi page 7

DISASSEMBLY
Remove the clamping pin, used to secure the plastic blocks
Then remove both plastic blocks. (This is also important when checking for
deformation in the pipe hook itself).
ASSEMBLY
During assembly of the clamp, you must perform the above instructions in reverse
order.
REMARK
In order to guarantee the safety of the pipe hook, you should only use our original
REMA parts, which have been marked, for repairs. Checks and repairs performed
by you or third parties are outside of our competence.
After inspection and/or repair, the clamps must be tested on a tensile strength
tester.
8