Num'axes CANICOM 200 First Guide D'utilisation page 25

Troubleshooting
Should your CANICOM 200 FIRST stop working or develop a fault, first read this user's guide over, then
check the batteries and replace them if necessary and retry. Also check that you are using the product
correctly.
If you encounter any problems, re-code the receiver collar with the remote control (ref. Coding
procedure).
Re-initialize the system by removing the battery from its housing, then with a metallic tool (e.g.
screwdriver, scissors) touch each of the 2 battery contacts for 2 seconds approximately (ref. Diagram 6).
Insert the battery again: One beep is emitted, indicating the battery is in correct position.
Restart your CANICOM using the remote control.
If the problem persists, contact your distributor or check out on www.numaxes.com.
You can also contact NUM'AXES at +33.2.38.69.96.27 or by Email export@numaxes.com.
Depending on the extent of the malfunction, you may have to return your product for service and repair.
For all repairs, please supply the following:
- the complete product
- the proof of purchase (invoice or sales receipt)
If you omit one of these items, the After Sales Service will have to invoice you for any repair costs
incurred.
CANICOM_200_First_indice_K 2017.indd 25
Gb - 25
Diagram 6
Reset: connect
the 2 supports of
the battery
17/05/2017 11:54