Num'axes CANICOM 200 First Guide D'utilisation page 19

Gb - 19
- Activate : approach the red mark located on the remote control until coming in contact on red mark
located on the receiver collar for 1 second (ref. Diagram 4). The indicator light on the collar will flash in
green indicating that the CANICOM receiver is on.
- Deactivate : approach the red mark located on the remote control until coming in contact on red mark
located on the receiver collar for 1 second (ref. Diagram 4). The indicator light on the collar will flash
from green to red and then off: the CANICOM receiver is off.
To increase the battery life of the receiver collar, you should deactivate the unit if you are not using
your CANICOM 200 FIRST for a long period.
Diagram 4
Approach until coming in contact those 2 areas
during 1 second
REMOTE CONTROL
RECEIVER COLLAR
 Coding of the remote control and receiver collar
Each remote control has its individual radio operator code. The coding of the remote control with the
receiver collar enables the two units to work together.
IMPORTANT: before beginning the coding, make sure no other person is using his CANICOM 200
FIRST or other products from the NUM'AXES range close by: your receiver collar could
accidentally record the code of his remote control. If that occurs, re-code the remote control with
the receiver collar.
CANICOM_200_First_indice_K 2017.indd 19 17/05/2017 11:54