Adjusting The Working Angle; Adjusting The Working Width; Adjusting The Working Depth - Stihl AHK 800 Notice D'emploi

8 Working with the Ridger
8.2

Adjusting the Working Angle

The working angle of the ridger can be adjusted.
► Stop the engine.
► Place the tiller on a level surface.
► Loosen lock nuts (1).
► Loosen screw (2).
► Unscrew screw (3) by turning anti-clockwise.
► Tighten screw (2) so bracket (4) is locked in place.
► Tighten lock nuts (1) firmly.
The working angle is decreased.
► Loosen lock nuts (1).
0478-906-9911-A
► Loosen screw (2).
► Screw in screw (3) by turning clockwise.
► Tighten screw (2) so bracket (4) is locked in place.
► Tighten lock nuts (1) firmly.
The working angle is increased.
8.3

Adjusting the Working Width

The working width of the ridger can be adjusted to five
levels.
► Stop the engine.
► Place the tiller on a level surface.
► Lift catches (1).
► Adjust ridger wings (2) so catches (1) can be hooked into
a bore.
► Allow catches (1) to engage.
The ridger wings are adjusted.
8.4

Adjusting the Working Depth

The working depth of the ridger can be adjusted to four
levels.
► Stop the engine.
► Place the tiller on a level surface.
English
23