XZENT X-127 Manuel De L'utilisateur page 6

MODE 1 (LOW OHMS BASED):
1 2
6 7
11
Mögliche Tastenfunktionen und Bedientasten
1. MUTE: short press to mute the XZENT audio output. Press again to undo the mute function.
2. Vol- short press to reduce the volume of the current active audio channel (media vol,
voice, etc.).
3. Vol+ short press to increase the volume of the current active audio channel (media vol,
voice, etc.).
4. Skip back short press to while media source DAB, USB, FM, etc. is active to do the same
touchscreen button operation.
5. Skip next short press to while media source DAB, USB, FM, etc. is active to do the same
touchscreen button operation.
6. Pickup short press to accept incoming call.
7. HangUp short press to end ongoing call.
8. SRC: Press to select a different Source via Main Menu highlighting.
9. FAV short press to execute assigned FAV function from device settings (see chapter
device settings).
10. CAM short press to open camera source. Press again to close.
11. Change short press to remove current steering wheel button assigments and reassign them
(see next Chapter).
12. Default wshort press to load default values of mode 1.
10
3 4 5
8 9 10
12
SWC (re)Assignment process:
The process is similar to both SWC modes and only differs by other standard and alternative buttons.
The standard and alternative buttons function are explained at the beginning of this chapter for each
mode. You can re-assign the buttons of your SWC. Please note that this mode is NOT for the IR-stalk in-
terface mode. Press the "Change" button to start re-assiging the functions to your liking. The system will
clear all buttons from the steering wheel and marks the top left SWC button which shall be assigned fi rst.
You need to assign all cleared buttons one by one from top left to bottom and then the right side from top
to bottom. The current button which is to be assigned with a function will be hi-lighted for you. Example:
To assign a function, select a function icon via touch from the middle (for example SRC / voice). After the
desired function (in this example SRC / voice) is marked, press the corresponding SWC-Button (in this
example top left). The system will now gray-out the SRC / voice button in the middle and put the SRC /
voice function to the top left SWC button. Later you can trigger SRC / voice by pressing the top left SWC
icon (instead of default MUTE). After the fi rst button is assigned, the system will hi-light the next button to
be assigned by a still available (non-grayed-out) function from the middle. After all buttons on the SWC
are defi ned – you can close the SWC assignment and use the new confi guration from now on. To resto-
re back to default values press the "Default" button. The functions will then restore to standard values.
Board/Trip-Computer:
The SWC buttons for trip-, board computer and cruise control operation are directly assigned to the rela-
ted vehicle functions, e.g. the function of these buttons on the steering wheel is completely independent
of the device mounted in the vehicle.
Note:
The SWC related functions are only available if the device is connected with a compatible stalk-interface
via IR in wire to a compatible vehicle model or via (Analog Key) if existing in the vehicle.
CAN IR stalk interface modules are being developed by various providers and, as soon as these are
available, details on support can follow.
The change from mode 1 to mode 2 must be completed by restarting the device.
11