Adjustment Of The Display Position - XZENT X-127 Manuel De L'utilisateur

ADJUSTMENT OF THE DISPLAY POSITION

Adjustment of the display position (vertical height, horizontal viewing angle and tilt).
The display of the X-127 can be adjusted vertically in height as well as in viewing angle and tilt.
Note:
• Adjustments to the display should not be made while driving.
• Observe the safety instructions of the vehicle. Also pay attention to the accessibility of buttons such
as warning lights or air outlets.
• The display should always be held with both hands „parallel" (left and right centered) to adjust it.
• The X-127 should be firmly mounted.
Viewing angle adjustment and tilt:
Grasp the display at the center of the left and right edges and push with one hand and pull with the
other to adjust the viewing angle. For the tilt angle, perform a tilting motion away from or toward your-
self with both hands.
Height adjustment:
Grasp the center of the display at the left and right edges and slide the display up or down.
Depth adjustment requires partial disassembly and adjustment of the standard mounting. Pay attenti-
on to the separate section explaining this.
CUSTOMIZING DISPLAY DEPTH ADJUSTMENT
The depth adjustment of the display can be changed from default 0" setup (0mm) to 1/2" (12.5mm)
or 1" (25mm).
A
A
Prerequisite: X-127 is disengaged from 1DIN dashboard and
no mounting cage is fitted.
To unlock the device from 1DIN dashboard, rotate the display
group to a 90° position by holding the panel group with both
hands and rotating it clockwise or anti-clockwise for 90°.
Loosen the trim bracket from main body and insert the device
release keys No.3 at corresponding gap on left and right side
(centre, between the main body and the 1-DIN mounting
bracket – see picture). The release keys need to be inserted
deep enough to disengage the clamp of the mounting bracket.
Pull the X-127 out once the mounting bracket clamps are fully
disengaged.
6
CUSTOMIZING AND DISPLAY DEPTH ADJUSTMENT
1
No.3
2
Note:
Do not remove
the center
screw
1" (25 mm) 1/2" (12.5 mm) Flush (default 0 mm)
3
Flush (default 0 mm)
1" (25 mm)
1/2" (12.5 mm)
Step 1:
Remove the cover No.14 of the adjustment
mechanism
Step 2:
Remove the 4 outer top screws and leave the center
screw fastened. Gently pull the display-mounting-
bracket by pulling on the display panel from the
chassis to the desired 1/2" or 1" position. To lock it in
place, fasten the 4 outer top screws (see figure).
On demo pictures the Display panel group is not
visible to allow better visibility of the top screws.
Step 3:
Reinstall or install the X-127 to 1DIN dash board
(see separate chapter). Installation process is same
as default but other covers No.14 for the adjustment
mechanism is required at the end.
7