i-tec USB 3.0 SATA HDD Mode D'emploi page 7

Notes:
Insert the HDD to the docking station carefully and push it gently and
ź
completely against the SATA connector so as to avoid damaging the connector
and so that the HDD is properly displayed in the OS.
Do not remove the HDD during the data transfer or during the cloning.
ź
We recommend reading the manual to your HDD before using it with the i-tec
ź
docking station.
Insert only 2.5" / 3.5" SATA HDD into the docking station, other devices or
ź
objects can damage the SATA connectors or the tilting strips.
FAQ
Question: Can I backup / clone the HDD after connecting the docking station to a
notebook / PC?
Answer: No. After connecting the docking station to a notebook / PC the inserted
HDDs work in the OS as two external HDDs and you can transfer data between them
or to them.
Question: The backup / cloning did not start after double-clicking the "CLONE"
button.
Answer: Disconnect the docking station from the notebook / PC. HDD1 must have
lower capacity than HDD2.
Question: After connecting the docking station to the notebook / PC the inserted
HDD is not visible. Why?
Answer: Before using, the new HDD needs to be formatted in the usual way in the
OS.
Question: After connecting the docking station to the notebook / PC there is no
signal.
Answer: First format the new HDD before using. Then check the power adaptor or
the USB 3.0 cable and their function.
In case of problems with the docking station, contact our technical support:
support@itecproduct.com.
Quick Start
EN EN
06 08