Vitrifrigo SCS Manuel D'utilisation page 10

Drip tray handling
EN
Drip tray can slide for allow the removal.
Drip tray grid handling
Drip tray grid can be removed also with the drip tray in position on the cooler.
Refrigerator switch on
When the refrigerator is switched on, but in standby mode, the thermostat's display shows alternatively
"OFF" and the inside temperature value.
To turn on the refrigerator, hold the button pushed for at least 3 seconds. You will see "ON" on the
display and immediately after the inside temperature value.
Once turned on, the fridge will start working, but it will take some time (also depending on external
conditions) to reach the required internal temperature.
We recommended to put milk inside the refrigerator only when the internal temperature has stabilized to
the required value.
Temperature setting
To set the desired temperature, push the button until you see the current set point value flashing,
then adjust the value using the button (to increase) and (to decrease); to store the new value
press again the button .