Risk From Moving Parts; Observations; Warranty Conditions - Sagola PSAM 107 Manuel D'utilisation

30/31
If sparks are caused by static electricity or if the slightest discharge is felt, STOP DISTRIBUTION
IMMEDIATELY. Stop the system until the problem has been identified and corrected.
In order to prevent the risk of static electricity, the equipment must be grounded in accordance
with the paragraph "Grounding".
Grounding
To avoid risks deriving from static electricity, ground the spray gun and all spraying equipment
being used or which are in the spraying area. CHECK the characteristics of the local electrical
supply for detailed grounding instructions, corresponding to the area and the type of equipment
used.
CHECK the grounding of all the spraying equipment.
1.- Electrical equipment: plug to a correctly-grounded current outlet. The extension cables must be
of 3 wires and sized correctly for the consumption of the equipment.
2.- Pneumatic equipment: Ground correctly.
3.- Product hoses: only hoses with an extension not exceeding 50m. may be used, in order to
ensure continuity of the grounding device. See Electrical Continuity of the Hose.
4.- Spray gun: grounding is made through a connection to a product hose or a correctly grounded
spray gun.
5.- Item to be painted. In accordance with the applicable legislation in force.
6.- Product container: In accordance with the applicable legislation in force.
7.- All containers of solvents used in spraying, in accordance with the applicable legislation current-
ly in force. Use only containers which are metallic and electrical conductors. Do not place these
containers on non-conductor surfaces such as paper or cardboard which interrupt the continuity
of the grounding of the element.
8.- To maintain grounding continuity during cleaning or decompression, always keep a metallic
part of the spray gun (hand protector) firmly pressed to the side of the container which is placed
on the floor, and then operate the gun.
Safety during spraying
Reduce the risk of product injection, static electricity sparks or splashes, by following the spraying
procedure described below.

14.4. Risk from moving parts

Moving parts are liable to injure or amputate fingers or other parts of the body. Keep away from
moving parts at start-up or when using a pump. Before checking or servicing the pump, follow the
compression procedure given on section 8.2 to avoid accidentally starting up the pump.

15. Observations

By following the instructions set out in this manual you will ensure good spraying and quality of
finish. Should you have any doubt, please contact the Technical Service of SAGOLA.

16. Warranty Conditions

This device has been manufactured with great precision and has been subjected to a large
number of controls before leaving the factory.
The WARRANTY is valid for three years, counted as of the date of purchase, which will be indicated
by the seller in the place provided for this purpose, together with his stamp.
Once the unit has been received, please complete the warranty and send this to the manufacturer
for validation.
This WARRANTY covers any manufacturing defect, which will be repaired without charge. However,
any malfunction resulting from the incorrect use of the unit, such as inadequate connections,
breakage due to dropping, or similar, the normal wear of components and in general any deficiency
not attributable to the manufacturer of the device, are expressly excluded. Likewise, the WARRAN-
TY shall be rendered null and void when it is evident that the unit has been handled by persons
other than our Technical Assistance Service.
ENGLISH