Eaton xComfort CHCA-00/01 Notice D'installation page 11

l xComfort devices MUST NOT be exposed to any mechanical stress (e.g. mechanical pres-
sure on the devices or strain on connection wires).
l xComfort devices MUST NOT be changed, neither in technical, mechanical and/or electrical
terms. Exception: Shortening of connection wires.
l Devices must not be opened.
l xComfort devices must be and stay accessible for programming, replacement and mainte-
nance purposes (i.e. NO wall-paper on distribution boxes, NO immuring etc).
l Torques for screw-type terminals on the device need to be respected! For terminals from
third-party suppliers (e.g. lustre terminals) you need to respect the manufacturers' technical
data.
l Once the job has been done, all the installation boxes need to be closed again. All live com-
ponents need to be touch-proof.
l Installation boxes and distributors must be flame-retardant in compliance with the respective
rules and regulations.
l Neutral conductor displacements in the system network used are NOT allowed and can
destroy/damage the devices.
l Phase and neutral conductor need to be correctly connected.
l Protective earth PE needs to be provided where required by terminal equipment (e.g. lamp
with a metal housing).
l After removing any xComfort actuators, the incoming capacitor of the actuators needs to be
discharged (risk of electric shock).
l Connecting the sensors and loads or consumers has to be done in accordance with the
technical section of our catalogue or with the mounting instructions supplied with each pro-
duct. All technical data and recommendations need to be respected.
l Any connection wires not used must be touch-proof.
l Country-specific waste disposal and environmental regulations (e.g. for defective devices,
batteries, ...) need to be respected.
Applications:
l xComfort products MUST NOT be used for safety installations and safety-relevant functions,
especially for:
m Safety temperature switches and limiting equipment of heating systems
m Final position detection and switch-off or safety functions related to the influence of the
weather on shading systems (wind,rain,hail ...)
m Safety and EMERGENCY STOP functions in general
11