Maintenance And Service; Maintenance And Cleaning - Bosch Professional GLL 2 Notice Originale

the tripod (14) or a conventional camera tripod. Tighten the measuring tool
using the locking screw of the tripod.
Roughly align the tripod before switching on the measuring tool.
Attaching with the holder
Using the holder (9), you can attach the measuring tool to various objects up
to 10 to 60 mm thick, e.g. to vertical or horizontal boards or pipes.
Loosen the fastening screw (8) of the holder, position the holder in the de-
sired location and retighten the fastening screw.
Place the measuring tool with the tripod mount (12) on the 1/4" screw (6)
of the holder and tighten it to secure it on the holder applying moderate
force. Do not tighten the measuring tool firmly as this could cause damage.
Roughly align the holder before switching on the measuring tool. To do this,
loosen the locking screw (7) of the holder and move the measuring tool into
a horizontal position at the desired height. Retighten the locking screw.
Laser Goggles (Accessory)
The laser goggles filter out ambient light. This makes the light of the laser ap-
pear brighter to the eye.
Do not use the laser goggles as protective goggles. The laser goggles
u
make the laser beam easier to see; they do not protect you against laser
radiation.
Do not use the laser goggles as sunglasses or while driving. The laser
u
goggles do not provide full UV protection and impair your ability to see
colours.

Maintenance and Service

Maintenance and Cleaning

Keep the measuring tool clean at all times.
Never immerse the measuring tool in water or other liquids.
Wipe off any dirt using a damp, soft cloth. Do not use any detergents or
solvents.
The areas around the outlet aperture of the laser in particular should be
cleaned on a regular basis. Make sure to check for lint when doing this.
Bosch Power Tools
English | 19
1 609 92A 58R | (04.03.2020)