Rear Panel - Roland EXR-46 OR Manuel D'utilisation

Rear panel

A OUTPUT R, L/MONO sockets
These sockets allow you to connect the EXR-46 OR to your
HiFi amplifier, a mixer, a cassette deck, a keyboard amplifier,
etc. If the external amplifier is mono, be sure to connect it to
the OUTPUT L/MONO socket.
B DC IN socket
This is where you need to connect the supplied adapter
(PSB-4U).
Note: Be sure to only use the adapter supplied with your
EXR-46 OR. Other adapters may damage your Interactive
Arranger.
C Cord hook
After connecting the adapter cable, wind it around the cord
hook to the socket's right to prevent accidental power fail-
ures.
D FOOTSWITCH socket
This is where you can connect an optional DP-2, DP-6, or
BOSS FS-5U footswitch that allows you to hold ("sustain")
the notes you play with your right hand. It can also be used
for controlling other parameters (see "FSW° (Footswitch
Assign)" (p. 40)).
A B C D
E MIDI OUT/IN sockets
Connect the MIDI OUT socket to the MIDI IN jack of your
computer (or MIDI instrument) to transfer MIDI data from
the EXR-46 OR to the computer or external MIDI instrument.
Connect the MIDI IN socket of the EXR-46 OR to the com-
puter's MIDI OUT jack to receive data from the computer.
Note: The EXR-46 OR can also transmit/receive MIDI data via its
USB port. To do so, you need to install the appropriate USB driv-
ers from the supplied CD-ROM.
F USB port
The USB port can be used for transmitting/receiving MIDI
messages or for archiving purposes with a computer.
E F
EXR-46 OR
11