Turning The Power On/Off; Replacing The Batteries - Korg KAOSS PAD mini-KP Manuel D'utilisation

Thank you for purchasing the Korg KAOSS PAD
mini-KP Dynamic Effect Processor. For trouble-
free enjoyment of the mini-KP's fullest potential,
please read this manual carefully and use the mini-
KP only as directed.
Parts of the mini-KP
LINE IN jacks
PROGRAM/BPM knob
PEAK indicator
Display
ON/STANDBY switch
HOLD indicator
HOLD button

Replacing the batteries

The display will indicate "Lo" when the batteries are
running low. Please replace the batteries as soon
as possible.
You must turn off the power switch before re-
placing the batteries.
The included batteries are provided so that you
can verify that the unit operates correctly, and may
have a shorter lifespan than expected.
Use only alkaline batteries.
If the batteries become unusable, remove them
immediately. You should also remove the batteries if
you won't be using the unit for an extended time.
1. On the bottom
panel, slide the bat-
tery case cover in the
direction of the arrow
to open it.
2. Install four AA bat-
teries. Make sure that
the batteries are in-
serted in the correct
polarity (+, -).
3. Close the battery
case cover.
DC jack
LINE OUT jacks
TAP/BPM button
MEMORY B button
MEMORY A button
Touch pad
VOLUME
PHONES jack

Turning the power on/off

Turning the power on
Set the ON/STANDBY switch to the ON position;
this turns the power on.
Turning the power off
Set the ON/STANDBY switch to the STANDBY po-
sition; this will turn the power off.
If you're using the mini-KP on battery power,
don't forget to turn the power off when you are done
using it.
AC Adapter (sold separately)
Connect the optional AC adapter to the DC 4.5 V jack.
Be sure to set the ON/STANDBY switch to the
STANDBY position before connecting the AC adapter.
Be sure to use only the specified AC adapter.
Connection setting
Hold down the MEMORY A button and press the B
button. Use the PROG/VALUE knob to select "dir"
(direct) or "snd" (send).
Choose the "dir" setting if you are connecting an in-
strument or audio device directly to the mini-KP (as
in the diagram above). Choose the "snd" setting if
the mini-KP will be connected to the effect send
and return jacks of your mixer or other device.
To return to the normal play mode, once again hold
down the MEMORY A button and press the B but-
ton. The mini-KP will also return to the normal play
mode (program selection state) after about three
seconds if no additional setting operations are per-
formed.
This setting will be remembered even when the
power is turned off.
About the input level
The PEAK indicator will light red if the input signal
level is too high. In this case, reduce the output vol-
ume of the device that's connected to the mini-KP.
The output level of the mini-KP will be smaller than its
input level. This is because the attenuator circuit is
connected at the input section, considering that the
mini-KP is used on battery power.