Motor Overriding System; Installation Layout - V2 ALFARISS Mode D'emploi

3.5 - MOTOR OVERRIDING SYSTEM

In case of absence of current, the gate can be released by
operating on the motor:
1. Open the hatch of the lock J in front of the motor
2. Insert the key K in the lock and turn clockwise to open the
hatch of the release on the side
3. Insert the key L into the hole and turn clockwise until reached
the limit switch
To restore the automation, proceed as follows:
1. Turn the key L anticlockwise until reached the limit switch,
then draw it out
2. Turn the key K anticlockwise closing the hatch of the lock,
then draw it out
3. Close the lock with the hatch J

3.6 - INSTALLATION LAYOUT

ALFARISS actuator
Rack
Flashing light with built-in antenna
Photocells
Key switch
Transmitter
Pillar photocells
Pillar-mounted digital radio switch
Safety edge (EN 12978)
Power supply cable 3 x 1,5 mm
-
Power supply 2 x 1 mm 2
cable 4 x 0,5 mm 2 (RX) - cable 2 x 0,5 mm
cable 2 x 1 mm 2
-
cable 4 x 0,5 mm 2 (RX) - cable 2 x 0,5 mm
-
-
33
2 (T100°C)
- antenna RG58
2 (TX)
2 (TX)