Special Features - Bosch 800 Serie Manuel D'utilisation

To set an oven timer:
Note: An oven timer cannot be run during Self Clean.
Press Oven Timer button.
1.
Select mode, press Enter.
2.
0:00 is displayed and blinks in the display. Enter the
desired timer value in H/MM format using the numeric
keypad.
Press the Enter button. The oven timer counts down to
0:00.
When the timer reaches :00 the cooking mode ends
3.
and the message "OVEN TIMER FINISHED" is
displayed. The oven alarm tone sounds every 10
seconds for 2 minutes.
Editing the oven timer:
If the oven timer is running and the time remaining
1.
needs to be changed, enter the oven timer mode by
pressing the Oven Timer button
The temperature blinks, indicating it can be edited.
2.
Input a new temperature or press Enter for no change.
The timer value blinks, indicating it can be edited.
3.
Input the new time and restart the timer by pressing
the Enter button.
The oven timer may be cleared by entering 0:00.
Fast Preheat
Fast Preheat heats the oven quicker than standard
preheat. It is available for Bake, Convection Multi Rack,
Convection Bake, Convection Roast, Roast and Pizza.
30
Roast is found in the "More Modes" menu. If Fast
Preheat is not allowed for the selected cooking mode an
error tone sounds. Fast Preheat is not available for Broil,
Convection Broil, Proof or Warm.
To set Fast Preheat:
Press Fast Preheat.
1.
The fast preheat icon appears in the display just above
the mode name.
Press Start.
2.
Fast Preheat can be turned off by pressing Fast Preheat
again.

Special Features

The special features provide you with additional
conveniences when cooking.
Learn more about these special features in the following
sections:
Probe (some models)
▯
Sabbath Mode
▯
Panel Lock
▯
Probe
The probe measures the internal temperature of the food.
The probe is available for Bake, Roast and all convection
cooking modes except Convection Broil.
Some models include a temperature probe used to
sense internal temperature of meats during cooking.
The probe ships with a black plastic safety cap over the
pointed metal end of the probe. The cap must be
removed prior to use.