Transport - WAGNER TempSpray-H126 Mode D'emploi

TempSpray-H326 / -H226 / -H126/ -H426
3.3

TraNSPOrT

TempSpray-H326 and TempSpray-H226:
Roll up the high-pressure hose and fix to the hose guide park
fitting. Coil connecting hose over the cable holder and con-
nect it to the park fitting as well. Roll up the mains connection
cable onto the cable holder.
Pull the locking pins (Item 1) on both sides of shaft. The lock-
ing pins can be arrested by a small turn (left or right). Pull the
shaft out and deblock the locking pins. A light pull or push will
help to lock the pins well.
Carry the device – don't throw it!
TempSpray-H126:
Roll up the high-pressure hose (roll diameter greater than 20 cm).
Then roll up the power cord as well. The advice can be trans-
ported with the Airless-unit on which it is mounted (See de-
tails for transport of the Airless-unit).
TempSpray-H426:
Drain the high-pressure hose as far as possible, in order to re-
duce the weight.
With the controller housing still mounted, roll up the high-
pressure hose (roll diameter greater than 80 cm).
Then roll up the power cord as well. The advice can be trans-
ported with the Airless-unit on which it is mounted (See de-
tails for transport of the Airless-unit).
1
GB
descrIptIon of unIt
35