Panasonic AW-HE870E Instructions D'opération page 67

Menu item setting/changing (Halogen, Fluorescent, Outdoor Mode)
Down-conversion mode selection
[Downconv. Mode: Squeeze, Sidecut]
Squeeze or Sidecut can be selected as the
down-conversion mode for the SD (576i) format.
Component output setting
[Component: RGB, Y/Pb/Pr, Y/C]
This enables RGB, Y/Pb/Pr or Y/C to be selected as
the component signals which are to be output from the
I/F REMOTE connector.
Y/C cannot be selected when "1080i" or "720p" has been
selected as the "Video output format (Format)" setting.
If "1080i" or "720p" has been selected using the video
output format selection function while Y/C is selected, the
component output will be changed to Y/Pb/Pr.
(Refer to "Changing the component setting" on page 85.)
AWB/ABB operation status display ON/OFF
selection
[Status: Off, On]
(Factory setting: Off)
Using this item, the display of the operation status for
AWB (auto white balance adjustment) or ABB (auto black
balance adjustment) is set to ON or OFF.
When AWB or ABB is executed with this item set to "On",
the following is displayed.
AWB ACTIVE:
AWB OK:
AWB NG:
OUT RANGE RB: This is displayed for 3 seconds after
HIGH LIGHT NG: This is displayed for 3 seconds when
LOW LIGHT NG:
- 66 (E) -
This is displayed while AWB is being
executed.
This is displayed for 3 seconds after
AWB was completed successfully.
This is displayed for 3 seconds after
AWB was not completed successfully.
(AWB executed while ATW, 3200K, or
5600K is selected)
AWB was not completed successfully.
(A colour that could not be adjusted
is displayed with RB)
adjustment is not possible because
the light quantity is too high.
This is displayed for 3 seconds when
adjustment is not possible because
the light quantity is too low.