Panasonic AW-HE870E Instructions D'opération page 20

Mounting
p Example where the camera is mounted on a ceiling or wall
(Ceiling)
Flat washers [*]
Spring washers [*]
Always mount
using the
Mounting screws [*]
anchor bolt.
(Inch screws: 1/4-20UNC)
Notes
p When installing the mounting bracket or attaching one end of
the drop-prevention wire to the ceiling or a wall, be absolutely
sure to use the anchor bolts, and ensure that the withdrawal
strength of the installation surface is at least ten times the total
mass of all units installed, including the mounting bracket,
camera, lens, and cables.
p Ensure that the total mass, including the mounting bracket,
camera, lens and cables, does not exceed 8 kg.
p Ensure that a drop-prevention wire is installed in such a way
that the drop distance does not exceed 150 mm.
The connection and installation should be done by qualified service personnel
or system installers. Refer any servicing to qualified service personnel.
Secure the end of the wire onto the
M6 anchor bolts by tightening nut or
secure it by tightening the M6 bolts.
Mounting screw for wire
(Inch screw: 1/4-20UNC) (supplied)
Spring washer (supplied)
Flat washer (supplied)
Drop-prevention wire (sold separately)
Camera mounting bracket [*]
[*]: Procured locally
(Wall)
Secure the end of the wire onto the
M6 anchor bolts by tightening nut or
secure it by tightening the M6 bolts.
Drop-prevention wire (sold separately)
Mounting screw for wire (supplied)
(Inch screw: 1/4-20UNC)
Spring washer (supplied)
Flat washer (supplied)
Flat washers [*]
Spring washers [*]
Mounting screws [*]
(Inch screws: 1/4-20UNC)
p Tighten the mounting screws using the torque levels shown
in the table to the below, and then check for play and
unsteadiness.
Screws
Mounting screws (Inch screws)
p Do not use an impact driver as doing so may cause damage to
the screws.
- 19 (E) -
Always mount
using the
anchor bolt.
Camera mounting
bracket [*]
[*]: Procured locally
Clamping torque
2.0 N • m (20 kgf • cm)