Panasonic AW-HE870E Instructions D'opération page 13

Precautions for installation
Parts to be provided by the customer for installation
When the unit is to be mounted onto a Panasonic pan-tilt
head, use the mounting screws and drop-prevention wire
that are supplied with the pan-tilt head.
Provide the following parts when the unit is to be mounted
onto a surface other than a pan-tilt head.
Drop-prevention wire* (sold separately): 1
(*Be absolutely sure to use the drop-prevention wire.)
Drop-prevention wires in three different lengths (300 mm,
450 mm and 600 mm) are available as optional
accessories.
Use a wire in the length that will have no slack to suit the
installation location and installation method.
Consult your dealer when you purchase one of these
drop-prevention wires.
Wire length (300, 450, or 600 mm)
(Camera
ø6.5
side)
ø4.2
ø1.2
Wire length (mm)
300
450
600
(Installation
ø6.5
side)
ø4.2
11 mm
Parts number
3CN001064BAA
3CN001064BAB
3CN001064BAC
- 12 (E) -
The connection and installation should be done by
qualified service personnel or system installers.
Refer any servicing to qualified service personnel.
Mounting screws (Inch screws: 1/4-20UNC): 2
(For mounting the camera)
Determine the length of
these screws by factoring
in the thickness of the
camera mounting bracket.
Mounting screws (M6) for installation end wire
At the installation location, be absolutely sure to use
the anchor bolts, and ensure that the strength of the
installation surface is at least ten times the total mass of
all units installed.
Flat washers for use with 1/4˝ screws: 2
(For mounting the camera)
Spring washers for use with 1/4˝ screws: 2
(For mounting the camera)
Camera mounting bracket: 1
Use a bracket made of a material and having a shape
that is strong enough to support the total mass of all units
installed, including the camera and lens.
To determine the position of the holes used for mounting
the camera, refer to <Bottom view> on page 13, and
make holes with a diameter of 7 mm (to support
1/4-20UNC mounting screws).
Camera mounting
bracket
7 to 9 mm