ResMed S9 VPAP Auto Information De Produit page 15

HUMIDIFIER WARNINGS
•
The H5i is designed only for use with S9 Series devices. Do not use the H5i with any other
device.
• Do not operate the H5i if it is not working properly or if any part of the device or H5i has been
dropped or damaged.
•
The H5i should only be used with air tubing or accessories recommended by ResMed.
Connection of other delivery tubes or accessories could result in injury, or damage to the device.
•
Water must be prevented from entering the device
•
Do not overfill the water tub as water may enter the device and air tubing.
•
Take care when handling your H5i as the water/water tub may be hot. Allow 10 minutes for the
heater plate and any excess water to cool.
• The H5i docking station should only be connected or disconnected when the water tub is
empty.
•
Make sure that the water tub is empty before transporting the H5i.
•
Do not operate the H5i on an aircraft as water may enter the device and air tubing during
turbulence.
•
Always place the H5i on a level surface below the level of the user to prevent the mask and air
tubing from filling with water.
•
The H5i should be used with caution for users who are unable to remove the mask for
themselves.
•
If liquids are inadvertently spilled into or on the H5i docking station, unplug the device from the
power outlet. Disconnect the docking station from the device and allow the docking station to
drain and dry before re-using.
•
Care must be taken to prevent the spilling of water on the device as this may cause the ingress
of water into the device case.
AIR TUBING WARNINGS
•
Do not use the air tubing if there are any visible signs of damage.
•
Do not wash the air tubing in a washing machine or dishwasher.
•
The ClimateLine/ClimateLine
MAX
is designed only for use with the H5i.
15
English