JVC KD-ADV6160 Manuel D'instructions page 37

Indications
WOOFER*
3
Subwoofer cutoff
frequency
HPF* 3
High pass filter
EXT IN*
6
External input
TAG DISP
Tag display
REAR SPK*
3, * 5
Rear speaker output
AMP GAIN
Amplifier gain control
AREA
Tuner channel interval
* 5 Displayed only when Dual Zone is activated (see page 32).
* 6 Cannot be selected if the source is "CD-CH" or "EXT IN."
Selectable settings, [reference page]
LOW:
Frequencies lower than 80 Hz are sent to the subwoofer.
MID: [Initial]; Frequencies lower than 120 Hz are sent to the
subwoofer.
HIGH: Frequencies lower than 160 Hz are sent to the subwoofer.
HPF ON: The cut-off frequency is chosen automatically
according to the WOOFER setting (LOW/MID/
HIGH) so that you can enjoy the low frequency effect
(LFE) purely from the subwoofer if it is connected.
HPF OFF:
[Initial]; Cancels.
CHANGER: [Initial]; To use a JVC CD changer, [40].
EXT IN: To use any external component (other than SIRIUS
DLP), [44].
TAG ON: [Initial]; Shows the ID3 tag while playing MP3/WMA
tracks, [42].
TAG OFF: Cancels.
ON:
[Initial]; Select this to turn on the rear speaker output.
OFF: Cancels.
You can change the maximum volume level of this receiver.
LOW PWR: VOL 00 – VOL 30 (Select this if the maximum power
of the speaker is less than 50 W to prevent them from
damaging the speaker.)
HIGH PWR: [Initial]; VOL 00 – VOL 50
OFF* 3 : Deactivates the built-in amplifier.
AREA EU: Select this when using the receiver in an area other
than North and South America. (FM: 50 kHz—manual
tuning, 100 kHz—auto search; AM: 9 kHz)
AREA US: [Initial]; Select this when using the receiver in North
or South America. (FM: 200 kHz; AM: 10 kHz)
37