Lenz Digital plus GOLDmini+ Manuel D'utilisation page 31

31
You can operate all functions during the signal stop or slow approach – you can even reverse away
again from the red signal! These special ABC modules can be used to assemble a very simple
E
block section. Activate the ABC module by setting Bit 2 (1) in CV51.
The ABC feature is not active whenever the shunting speed is switched on or the delay is disabled.
5.8 Push-pull train control
A push-pull train control can be set if the ABC braking module is used. There are two different
options: push-pull operation with and without intermediate stops. The latter also takes slow-
approach sections into account.
The push-pull train control is activated in CV51, Bit 4 (3) and Bit 5 (4). The stopping time at the end
of the track is set in CV54 (1 to 255 sec).
5.9 Allocating function outputs to the functions of the digital system (mapping)
Here you can define which function of the digital system is used to switch the function outputs A and
B on or off. The outputs A and B can be allocated to functions F0 and F1 (direction-dependent) or
functions F2 to F28 as desired.
This is allocated in CVs 33 to 46 and in CV129 to 144.
5.10 Lighting effect at function outputs
The lighting effect for the function outputs A and B is set in CV60. If you wish to switch the effects
with a function of the digital system, you can make the allocations to functions F1 to F8 in CV61.
The effects available are shown in the table of the supported CVs further below.