Seal The Cooktop With Foam Tape; Install The Cooktop; Connect Gas Supply - Bosch NGM54 55UC Mode D'emploi

extends beyond the outermost flange of the cooktop. All
corners should be covered with tape.
Cutout shows location
of Aluminum Reflective Tape
Heat Reflective Tape
Figure 3: Counter Cutout – Solid Surface Countertops

.Seal the Cooktop with Foam Tape

Note:
Failure to install the foam tape may affect burner
performance.
Apply the self adhesive foam tape in one continuous
rectangle directly to the counter around the perimeter of the
cutout as shown by the dotted line in Figure 4: "Counter
Cutout – Foam Tape Placement". The foam tape should be
flush with the edge of the cutout.
Cutout
Figure 4: Counter Cutout – Foam Tape Placement
9001172130 Rev A

Install the Cooktop

Insert cooktop into the cutout. Attach clamps of the hold-
down brackets packaged with the cooktop. Use the washer
and screws provided.
A
A
Section "A - A"
Adjust hold-down brackets to desired position and tighten
screws to cooktop. Insert adjusting screw into clamp and
secure cooktop to countertop.
NOTE:
For solid surface material installations: Insert a wooden
block between the end of the screw and the bottom of the
countertop. Do not overtighten adjusting screw. Trim
excess aluminum tape around cooktop flange.
Foam
Tape

Connect Gas Supply

The gas inlet to the unit is located at the right rear of the
cooktop.
Install the pressure regulator (supplied with unit) to
manifold pipe using Teflon tape on threads of manifold
pipe. Turn to hand tighten plus 1/4 turn, not exceeding 1
Cooktop
Foam
Tape
(Seal)
Clamp
Adjusting
Screw
Adjusting
Screw
Figure 5: Attaching Hold-Down Brackets
Opening for Gas
Connection and
Electrical Cord
1"
Wooden Block
(to be used with
solid surfacing
material, i.e.
Surell™ and
Corian®)
Clamp
C of Cutout
L
9 3/16" (233 mm)
Figure 6: Cooktop Area
English 10