Intended Use - VOLTCRAFT B6 Notice D'emploi

2. Intended Use

The "Multi charger discharger B6" is used to charge NiCd + NiMH type batteries (1-16 cells),
LiPo/LiIon/LiFe batteries (1-6 cells) and lead acid batteries (1-10 cells, 2V-20V). The charge
current can be set between 0.1A and 5.0A depending on the connected accumulators and their
cell number/capacity.
Accumulators can also be discharged; the discharge current is between 0.1 to 1.0A.
The charger may only be connected to a direct current between 11V and 18V.
A two-line illuminated LCD display and four buttons are used to control the charger.
A balancer is integrated into the charger for LiPo/LiIon/LiFe batteries, with balancer connector
sockets for the accumulator located on the side of the charger.
The product is intended for use in dry indoors, it must not get damp or wet!
Any use other than that described above could lead to damage to this product and involves the
risk of short circuits, fire, electric shock, etc.
No part of the product should be modified or reassembled.
Observe all safety instructions and information within this operating
manual.
3. Contents
• accumulator charger
• current connection cable with crocodile clips for connecting to supply voltage
• set of connector cables
• Aluminium storage case
• Operating instructions
51