JVC KD-X441DBT Manuel D'instructions page 29

TROUBLESHOOTING
Symptom Remedy
Cannot playback at • Make sure JVC MUSIC PLAY APP is installed on the Android
[AUTO MODE]. device. ( 9)
• Reconnect the Android device and select the appropriate
control mode. ( 10)
• If this does not solve the problem, the connected Android
device does not support [AUTO MODE]. ( 25)
"NO DEVICE" or • Switch off the developer options on the Android device.
"READING" keeps • Reconnect the Android device.
flashing. • If this does not solve the problem, the connected Android
device does not support [AUTO MODE]. ( 25)
Playback is intermittent Turn off the power saving mode on the Android device.
or sound skips.
"CANNOT PLAY" • Make sure Android device contains playable audio files.
• Reconnect the Android device.
• Restart the Android device.
No Bluetooth device is • Search from the Bluetooth device again.
detected. • Reset the unit. ( 3)
Pairing cannot be made. • Make sure you have entered the same PIN code to both
the unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. ( 11)
Echo or noise occurs. • Adjust the microphone unit's position. ( 11)
• Check the [ECHO CANCEL] setting. ( 13)
Phone sound quality • Reduce the distance between the unit and the Bluetooth
is poor device.
• Move the car to a place where you can get a better signal
reception.
Symptom Remedy
Sound is being • Reduce the distance between the unit and the Bluetooth
interrupted or skipped audio player.
during playback of a • Turn off, then turn on the unit and try to connect again.
Bluetooth audio player. • Other Bluetooth devices might be trying to connect to the
unit.
The connected Bluetooth • Check whether the connected Bluetooth audio player
audio player cannot be supports Audio/Video Remote Control Profile (AVRCP).
controlled. (Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
"PLEASE WAIT" The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the unit,
then connect the device again.
"NOT SUPPORT" The connected phone does not support Voice Recognition
feature.
"ERROR" Try the operation again. If "ERROR" appears again, check if
the device supports the function you have tried.
"H/W ERROR" Reset the unit and try the operation again. If "H/W ERROR"
appears again, consult your nearest service center.
If you still have troubles, reset the unit. ( 3)
27
ENGLISH