JVC KD-X441DBT Manuel D'instructions page 17

BLUETOOTH®
Bluetooth mode settings
1 Press and hold .
2 Turn the volume knob to select an item (see the following table), then press the knob.
3 Repeat step 2 until the desired item is selected/activated or follow the instructions
stated on the selected item.
4 Press to exit.
To return to the previous setting item, press
BT MODE
PHONE SELECT *
Selects the phone or audio device to connect or disconnect.
" " appears in front of the device name when connected.
AUDIO SELECT *
" " appears in front of the current playback audio device.
1 Turn the volume knob to select a device to delete, then press the knob.
DEVICE DELETE
2 Turn the volume knob to select [YES] or [NO], then press the knob.
PIN CODE EDIT Changes the PIN code (up to 6 digits).
(0000) 1 Turn the volume knob to select a number.
2 Press
1
Repeat steps
3 Press the volume knob to confirm.
RECONNECT ON: The unit automatically reconnect when the last connected Bluetooth device is within range. ;
OFF: Cancels.
AUTO PAIRING ON: The unit automatically pair supported Bluetooth device (iPhone/iPod touch/Android device)
when it is connected through USB input terminal. Depending on the operating system of the
connected device, this function may not work. ; OFF: Cancels.
INITIALIZE YES: Initializes all the Bluetooth settings (including stored pairing, phonebook, and etc.). ;
NO: Cancels.
INFORMATION MY BT NAME: Displays the unit name ("KD-X4
MY ADDRESS: Shows address of this unit.
* You can only connect a maximum of two Bluetooth phones and one Bluetooth audio device at any time.
.
to move the entry position.
2
and until you finish entering the PIN code.
DBT"). ;
Bluetooth compatibility check mode
You can check the connectivity of the supported
profile between the Bluetooth device and the unit.
• Make sure there is no Bluetooth device paired.
1
Press and hold
"BLUETOOTH"
"SEARCH NOW USING PHONE"
scrolls on the display.
2
Default: XX Search and select "KD-X4
Bluetooth device within 3 minutes.
3
Perform (A), (B) or (C) depending on what
appears on the display.
(A) "PAIRING"
Ensure that the same passkey appears on the
unit and Bluetooth device, then operate the
Bluetooth device to confirm the passkey.
(B) "PAIRING"
the Bluetooth device.
(C) "PAIRING": Operate the Bluetooth device to
confirm pairing.
After pairing is successful, "PAIRING OK"
Name]" appears and Bluetooth compatibility check
starts.
If "CONNECT NOW USING PHONE" appears, operate
the Bluetooth device to allow phonebook access to
continue.
"TESTING" flashes on the display.
.
"CHECK MODE" appears.
"PIN IS 0000"
DBT" on the
"XXXXXX" (6-digit passkey):
"PIN IS 0000": Enter "0000" on
"[Device
ENGLISH
15