Heatsail DISC Manuel D'utilisation page 16

EN
S T E P 8
Unwind power cable from DISC
and feed cable through the
included stem. The threaded
holes have to face downward
towards the DISC.
Identify the holes in the mounting
bracket and make sure they
match with the holes (A) shown
at right. Secure the DISC using
two M6 set screws.
NOTE: DO NOT tighten them fully;
they have to stick out 1/16 of an
inch.
NOTE: Use the black or gray set
screws depending on the color of
your DISC.
S T E P 9 a
Secure two set screws in the
holes (B) to adjust the lift
and level of the DISC to make
it parallel to the ground by
backing the set screws in or
out. Tighten them fully.
After feeding the power cable
through the stem, gently slide
the cover of the ceiling rose/
medallion over the stem and
allow to rest against the top of
the DISC hood.
16
A
B B
A
B B
Heatsail DISC® PENDANT