Heatsail DISC Manuel D'utilisation page 14

NL
EN
S T A P 2
S T E P 4 a
Gebruik de template om de
gaten te boren waar de beugels
Use the metal bracket and a
aan gemonteerd worden
pencil to mark where the bracket
4 universele pluggen zijn
will be mounted.
bijgeleverd (boordiameter 8 mm)
Four universal 8mm screw anchors
Deze zijn niet geschikt voor alle
are included.
oppervlakten!
S T E P 4 b
Installeer de pluggen
Using the drill, make four holes in
the locations marked in Step 4a.
Install the screw anchors in the
intended holes. Gentle tapping
with a hammer may be needed to
fully seat the screw anchors. When
properly installed, the anchors will
be flush to the mounting surface.
NOTE: If the supplied hardware
is not suitable for your surface,
please contact your local hardware
supplier.
NOTE: Do not screw the bracket in
place at this moment.
S T E P 5
Rubber gaskets with adhesive
backing are provided if necessary
for a tighter seal.
14
14
993 mm
Heatsail DOME®
Heatsail DISC® PENDANT