Kratki AQF 01 Instructions De Montage Et D'utilisation page 32

EN
INSTALLATION OF GAS CONTROL SYSTEM
ATTENTION!!! This appliance together with the gas control system can only be installed at the
factory settings.
ATTENTION!!!
Individual elements of the gas control system should be installed in accordance with the instruc-
tions in this manual.
Never connect the appliance directly to the gas cylinder, without the gas pressure regulator!
The standard gas control system includes a manual control valve. Elements of the system should be
installed in places designated for this. Moving them may expose the device to damage due to harmful
temperatures or flooding.
The appliance can only work with the gas control valve supplied with the appliance. Connections of
individual system components have been made in such a way as to prevent their improper connec-
tion. (Fig. 3.)
WARNING! The appliance is equipped with a very sensitive anti-tilt valve. Shaking of the table as
a result of impact or other forces in which the device will be installed may cause cutting off the
gas supply to the device, and thus shutting it down. If you report that the device does not burn,
immediately turn the knob to the shut-off position clockwise and according to the instructions
in the section „lighting the appliance".
CONNECTION TO THE GAS SOURCE (GAS BOTTLES/CYLINDERS)
Connect the regulator to the cylinder making sure that the seals are in place (See diagram above), if
the seals are old or damaged or if one of them is missing, the device cannot be used until the seals
are replaced. The valve must remain in the position it is installed at the factory. Changing the angle of
the valve with anti-tilt valve results in closing the gas supply to the device and thus switching it off.
ATTENTION!!! The anti-tilt valve is a protection against overturning of the appliance, thanks to which
in the event of the appliance overturning, the valve automatically cuts off the gas supply to the con-
troller, which extinguishes the flame.
ATTENTION!!! The appliance should be connected to the gas source only when the heater is turned off
and the cylinder valve is turned off.
ATTENTION!!!
It is forbidden to use open fire during the installation process or connecting the cylinder. Failure
to comply with this prohibition may result in fire, explosion, property damage, personal injury, and
even loss of life.
ATTENTION !!! Gas garden fireplaces are designed to work with a propane and propane-butane cy-
linder in size of 5 and 11 kgs (the sizes may vary depending to the country you are buying them in).
The device is sold with complete automation, tilting valve, reducer and connecting cables. Do not use
a hose other than that installed or indicated by the manufacturer, or any other system components.
32