Installation Rules - Kratki AQF 01 Instructions De Montage Et D'utilisation

EN
INSTALLATION - INTRODUCTION
SET COMPONENTS - FIRST UNPACKING OF THE PURCHASED HEATER
Connection of a gas garden fireplace to liquefied gas cylinders, as well as its adjustment and chec-
king the tightness of the installation should be made only by an authorized gas equipment installer
or authorized service technician in accordance with applicable regulations, which should be confir-
med on the product warranty card. Lack of such confirmation voids the warranty!
APPLIANCE INSTALLATION AND STORAGE OF BOTTLES SHOULD BE COMPLIANT WITH APPLI-
CABLE LAW
This appliance has an open combustion chamber without the option of connecting it to a chimney
flue. The gas garden fireplace is sold with pre-installed gas control control system, however, before
the first use it is recommended to check the tightness of the system due to the possibility of unsealing
in transport. All instructions regarding the correct connection of the system, installation in the table,
frames etc. can be found below in the further part of the manual.
NOTES ABOUT HANDLING:
This appliance is designed for an easy installation and movement. Before moving it, make sure that
all anti-removal components have been uninstalled, the gas supply has been cut off, and the hose
is disconnected from the gas garden fireplace valve. Moving the appliance while it is in operation
is strictly prohibited. After placing the gas garden fireplace in the desired place, secure it against
slipping, falling out or falling over.

INSTALLATION RULES

Installation should be carried out in accordance with the requirements of the law in force in the given
country or region. In the absence of such provisions, the rules contained in this manual and the princi-
ples of fire safety should be followed.
This appliance has been tested for quality and safety and has been certified by a notified testing la-
boratory.
WARNING!
The gas garden hearth is adapted to work with a cylinder or a household tank of a propane-butane
gas mixture. The flexible connection pipe should be intended for LPG from the cylinder.
The cylinder has to be putted into the specified housing with an easy access to this cylinder
after installation.
The device is sold with complete automation and cables connecting the main burner and control
with the controller. Do not use replacement system components other than those installed or sup-
plied by the manufacturer.
26