Operating Instructions; Selection Of Number Of Engines; 433 Mhz Built In Receiver; Power Adjustment - Dea 212 E Notice D'emploi

Operating instructions and warnings
only for qualified personnel
WARNING: Ensure to connect the phase cable to the "L" clamp and neutral to the "N" clamp.
WARNING: Use operators with thermal protection only and with 400V maximum tension resonance.
Factory settlements allow the use of standard system without any installer's programming support. If ne-
cessary, operation parameters may be personalized.
SEL and SET switches and signalling led allow control board settlements and programming. All program-
ming functions may be done at control board ignition or after a closing cycle.

8.1 Selection of number of engines

1. Press SEL repeatedly until the "1-2MOT" led lights
2. Press SET and soon release: "1-2MOT" starts flashing showing the selected statement (rapid flashing
= 2 motors working; slow flashing = 1 motor working)
3. Press SEL to change type of program
4. Press SET and soon release: "1-2MOT" led lights fixed (new memorized statement). Now press SEL to
select another programming function or exit from the programming (all extinguished leds)
WARNING: when 1 motor works "FCA/SIC2" and "FCC" inputs work as opening and closing end of
stroke. When 2 motors are working, "FCA/SIC2" input works as input for the sensitive edge mounted
on the wing n.2, "FCC" is not active. In any case short-circuit to the common the unused inputs.

8.2 433 Mhz built in receiver

Radio control learning:
1. Press repeatedly the "SEL" key to turn the RADIO led on.
2. Press (once) the "SET" key: the RADIO led starts flashing and shows the receiver learning status.
3. Press the radio control key you want to settle. The led lights up for a second, then starts flashing (learned key).
4. For any other key or radio control, repeat step 3.
5. Wait for the led to light up (learning complete). At this point press on the "SEL" key to select any other
programming function or to exit the programming (all leds are turned off).
Radio control memory reset:
1. Press repeatedly the "SEL" key until the RADIO led turns on.
2. Press the "SET" key and continue to press it until the led starts quickly flashing (under cancellation),
release the key.
3. Wait for the led to light up (cancellation settled). At this point press the "SEL" key to select any other
programming function or to exit the programming (all leds are turned off).
Please note: the control board detects automatically the type of radio control at first learning (dipswitch or
rolling code), in the future it will receive only same coding radio controls.
8.3 Operator force adjustment
1. Press repeatedly the "SEL" key until the led "FORZA" lights up.
2. Press the "SET" key and soon release: the display shows the force value settled at the moment (8 levels
are available, see table).
3. Press the "SEL" key to obtain the configuration led corresponding to the desired force value.
4. Press the "SET" key and soon release: the "FORZA" led lights fixed up (new memorized force value). At
this point, press the "SEL" key to select any other programming function or to exit the programming
(all leds are turned off).
10
Force Level
30%
40%
Led flashing
50%
60%
Led lighted on with fixed light
70%
80%
90%
100%